Maple Leaf Proudly Canadian Owned & Operated Since 1994
SnowWhite 13.8KG Package
  • SKU: EPSWK10-13.8KG
  • Availability: in stock Many in stock Out of stock You can purchase this product but it's out of stock

SnowWhite 13.8KG Package

Shipping calculated at checkout.

½” to 1 ½” Thick per Layer

Compatible with Most Finishing Methods & Substrates

No Need to Measure Pigments

Between Layers, and Between Projects

Highly Pigmented, Pre-blended Casting Epoxy for Opaque Whites

SnowWhite uses a simple 2:1 mix ratio and is highly pigmented. It has been formulated for large casting applications, such as river tables or large furniture pieces. The high opacity, pure white color beautifully contrasts wood grain in live edge projects and allows the reclaimed wood to shine.

SnowWhite consists of fillers and extra-white pigments suspended in epoxy resin allowing for a uniform and incredibly vivid white finish. It has excellent air release and low exothermic heat buildup to allow for easy casting while preventing stress cracking. Compatibility of the cured system with a variety of finishing methods and products ensures that desired custom finishes can be achieved.

SnowWhite Specifications

Times based on a 38mm (1.5”) deep casting at a volume of 14L. Individual project times may vary depending on pour depth, volume, ambient temperature, and humidity.

Pour Depth: 13-38mm (0.5-1.5”) for pours up to 16L

Mix Ratio by VOLUME: 2:1

Mix Ratio by MASS: 3.1:1

Working Time (in mold): 7 Hours

Tacky to Touch: 15-22 Hours

Set to Touch: 22 Hours

Demolding Time: 2 Days

Time Finishing: 3 Days

Full Cure: 3 Days

Working Temperature: Resin, mold, and workspace temperatures should be 20-25°C (68-77°F)

Clean Up: Isopropyl/Denatured Alcohol or Warm Soapy Water

Mixing Instructions

Mix resin for 1 minute before adding hardener. Add hardener to resin pail and mix thoroughly for 4 to 5 minutes. For less than full kit mixing, a 2:1 by volume (3.1:1 by weight) mix ratio must be used. Always use hand and eye protection when working with or near epoxies.

Application Instructions

Working area should be clean, dry, and free of dust. SnowWhite can be poured at 13-38mm (0.5-1.5”) per layer. SnowWhite will not shrink while curing under normal conditions. However, it may slowly fill cracks and voids in live edge wood pieces, causing the resin level to drop. Be prepared to add more epoxy as needed.

Epoxy releases heat when curing. For pours of 30L or more, multiple thinner pours may be necessary to prevent overheating. Fans blowing across the curing epoxy may also be used to help dissipate heat. For best adhesion between layers, wait until the first layer is tacky to touch before pouring a second layer. If the previous layer is no longer tacky, sand with 220 grit sandpaper and wipe down before pouring another layer.